Aug 12, 2021 · :water to air heat exchanger
Sep 15, 2018 · For these heat exchangers water, refrigerant or steam usually flows through the inside and air flows on the outside. For example, when used for heating air, using heated water, the hot water flows inside the tube and transfers its thermal energy via convection to the tube wall, there is a temperature difference between the hot water and the air Heat Exchanger Manufacturer, Hampton Falls, NHOn the refrigerant side, the close tolerances between the water coils and the condenser shell, result in the extraordinary heat exchange performance during condenser duty on the cooling cycle. As they are designed to also suit reversible applications, the unique design provides a high level of performance when the heat exchanger is used as a
The heat exchanger is installed in the discharge line between the commercial refrigeration compressor and condenser, whether the condenser is of the water or air cooled type. The heat exchanger is designed to pick up not over 25% of the total rated load of the condenser. In an ordinary commercial refrigeration system, about 30% of the work of Hot Water From Refrigerant Hot Gases - Energy DepotWith refrigerant gas-to-water heat exchangers, care must be taken not to reduce superheat to a point that allows liquid slugging and the heat exchanger must be located after the hot gas bypass or other unloading devices. If the exchanger is located outdoors, drains must be provided to prevent freezing.
B100 Condensate separator W100 Heat exchanger B200 Refrigerant separator W10L Air / Air heat exchanger B300 Refrigerant collector W10K Air / Refrigerant exchanger M200 Fan W110 Heat exchanger insulation V100 Refrigerant compressor W200 Refrigerant condenser EICA Microprocessor control X100 Schrader valve (for filling refrigerant) EI- Refrigeration Using Plate Heat ExchangersBrazed Plate Heat Exchangers. Our Plate Heat Exchangers can be used in refrigeration systems to transfer heat between liquid refrigerant leaving the condenser on the high-pressure side of the system, or refrigerant vapour leaving the evaporator on the low side. We recommend using our line of Brazed heat exchangers for the purposes of Refrigeration.
16 rows · Refrigerant heat exchanger selection is predominantly dependent on nominal system horsepower. The HXR and LHXR models are rated for 10 °F liquid subcooling and 20 °F suction gas superheat for R-22 and R-502 systems. At this rating point the system is
Your email address will not be published.*