Shell and Tube Type Heat Exchanger

Section 5.4 Shell and Tube Heat Exchanger Corrected

Shell-and-tube heat exchangers can have multiple passes, such as 1-1, 1-2, 1-4, 1-6, and 1-8 exchangers, where the first number denotes the number of the shells and the second number denotes the number of passes. An odd number of tube passes is seldom used except the 1-1 exchanger. A 1-2 shell-and-tube heat exchanger is illustrated in Figure 5.19.

Shell and Tube Type Heat Exchanger Explained - saVRee

• Parallel, Counter and Cross Flow Basics of Shell and Tube Heat Exchangers (With PDF) What DESIGN OF SHELL AND TUBE HEAT EXCHANGER - EPCM
  • Introduction to Design of Shell and Tube Heat Exchanger (PDF) Shell & Tube Type Heat Exchangers:An Overview Tubes The tubes are the basic components of a shell and tube type heat exchanger. The outer surfaces of the tubes are the boundary along which heat transfer takes place. It is therefore recommended that the tubes materials should be highly thermal conductive otherwise proper heat transfer will not occur. TYPES OF SHELL & TUBE HEAT EXCHANGERSA fixed-tubesheet heat exchanger has straight tubes that are secured at both ends to the tubesheets welded to the shell. Following three TEMA types of fixed-tubesheet heat exchangers can be made AEL:Removable channel covers

    Shell-and-Tube Heat Exchangers McMaster-Carr

    Also known as shell and tube heat exchangers, these transfer heat using liquid or steam that flows through the shell to heat or cool liquid in the tubes. Theyre commonly used in refrigeration and engine cooling systems. Btu/hr. cooling capacity is based on cooling 180° F process water with 85° F water and a 10 psi pressure difference.