Large Steam System Condensers:Heat Exchanger Knowledge Heat Exchanger Companies Suppliers. The steam condenser, shown in Figure 9 below, is a major component of the steam cycle in power generation facilities. It is a closed space into which the steam exits the turbine and is forced to give up its latent heat of vaporization.
majority of the time the heat exchangers will operate at less than design conditions. As the temperature regulator modulates toward the closed position allowing less steam to pass, the steam in the heat exchanger will expand causing a reduced pressure and reduced steam temperature. A steam trap is connected to the heat exchanger shell to Steam Control and Condensate Drainage for Heat Jul 17, 2014 · The fluid in the condensate cooler tubes may be the inlet water to the steam heat exchanger tubes. When the initial temperature of the fluid is too high to cool the condensate below 212°F, a separate fluid may be heated. Preheating domestic hot water or preheating boiler make up water are two possibilities.
When it is necessary to operate a heatexchanger at high pressure (above 15 psig)a condensate cooler can be added to sub-cool the condensate below 212°F. Theillustration shows the proper steam trap-ping for a condensate cooler. The incom-ing fluid to the steam heat exchanger maybe used to sub-cool if the temperature islow enough. A separate cooling sourcemay also be used. Steam Condenser:Basics, Parts, Advantages, and Jun 08, 2021 · A steam condenser is a closed vessel-type heat exchanger applied to convert low-pressure exhaust steam from the turbine to water. A steam condenser is a mechanical device employed to condense exhaust steam of the turbine into the water. It conducts this process with the help of cooling water that circulates inside it from the cooling tower.
Your email address will not be published.*